Castors for 'Clap' hammock stand | Solid rubber tires with metal screws | W 32 cm Ø 12.5 cm | Made in Austria

The 'Clap' wheel set is an effortless and practical accessory for the hammock stand of the same name. The hammock stand, which can be assembled and folded away in an instant, can be moved or stored even more easily with the help of these wheels. What better way to relax and enjoy your free time than with this inconspicuous little helper?

• exceptionally light and easy to adjust and store
• made of solid rubber and metal
• requires only one drill hole per side
• easy to retrofit

The hammock stand, crafted from high-quality ash wood, is very convenient to move and effortless to store thanks to the solid rubber tires on both sides. The wheels can also be easily retrofitted to existing hammock stands. You only need to drill 2 holes and attach the wheels using the included screws. To move the stand, you simply need to lift it slightly from the end opposite the wheels. Independent sliding is impossible.
Tip: Clean dirty wheels if necessary and tighten the cap nuts if required.


Material:
Solid rubber tires
Metal screws

Dimensions:
Diameter 125 mm
Width 32 mm

Load capacity:
250 kg

Included in delivery:
2 wheels
2 M10 washers
2 stainless steel sleeves
2 screws
2 cap nuts

Assembly:
1. - 3. only apply if the wheel set is being retrofitted. Otherwise, the holes are already pre-drilled.

1. measure 6 cm inwards from the outer edge of the wood
2. measure 6.5 cm inwards from the outer plastic edge
3. drill a 10 mm hole through the wood at the intersection of the two measured points
4. insert the screws from the outside in
5. mount the axle and wheel on the inside

Attention: No liability is accepted for accidents resulting from improper assembly or handling. Compliance with the stated assembly and operating instructions is a prerequisite for any warranty claims.